FALMEC POLAR Manual De Instrucciones página 20

Before performing any cleaning or maintenance operations, disconnect the
appliance by unplugging it or using the main switch. The manufacturer dis-
claims all liability for any damage that may be directly or indirectly caused
to people, things and animals due to the failure to follow all the instructions
provided in this booklet and above all the warnings relating to the installa-
tion, operation and maintenance of the appliance.
N
WARRANTY
The new equipment is covered by warranty.
The warranty conditions are provided by the distributor.
The manufacturer is not liable for any inaccuracies in this booklet resulting
from printing or transcription errors. The manufacturer reserves the right to
modify its products as it considers necessary or in the interests of the user,
without compromising their essential safety and operating characteristics.
O
MOUNTING INSTRUCTIONS
FOR POLAR ISOLA HOOD
Step 1
1) Remove the screw that fix the extension to the iron frame work (only for
transport) (det. A, fig. O2).
2) Fasten the iron framework (C) to the ceiling using the six Ø8 expansion
plugs and relative screws (V1) (fig. O1).
3) Identify the height (65-70 cm) required for the positioning of the range
hood (fig. O2).
Step 2
1) Fasten the chimney + extension + inferior framework assembly (B+D+G)
on the superior framework (C) using the 6 screws (V2). During this opera-
tion the inferior framework (G) have to slide internally from the superior
framework (C) (fig. O3).
2) For suction version: identify the optimal height for the rigid or flexible
exhaust pipe and connect it to the motor pipefitting.
3) Make electrical connection only ofter having removed the electrical power
supply.
4) Raise the extension (D) to the iron framework flange and turn it to fix the
extension to the flange (fig. O4), then fastenthe extension to the iron fra-
mework (C) using the enclosed metric screw (V3).
HOOD WITH GLASS (fig. O6)
1) Remove the metal filter using the handle (M).
2) Disconnect the connector (S) of the halogen light cable.
3) Remove the inferior cone (A) screwing off the 4 metric screws (V4).
4) Unscrew just a little the safety screws (V5) and centre the glass slot to
avoid the rotation of the glass.
5) Hang the inferior cone (A) to the chimney +extension assembly (B+D)
using the 4 metric screws (V4).
6) Connect the connector (S).
7) Fix the metal filter using the handle (M) (fig. O5).
18
All manuals and user guides at all-guides.com