Herschel Select XLS Serie Instrucciones De Instalación Y Funcionamiento página 12

Herschel Easy-fix mounting system
Preparation – Important Notice
When the EasyFix bracket is fitted to the panel, it will be offset from centre due to the locking movement. To
ensure your panel fits exactly where you want it on the wall or ceiling (white panels only), it is important
before installing that you place the bracket on the panel in its locked position and measure the distance of the
mounting holes to the edges of the panel before then marking, checking and drilling them on the wall (or
ceiling) to cater for this offset.
Step 1
Use a spirit level to ensure the bracket is level and
mark the position for drilling in each of the small
holes in the four corners of the mounting bracket
(figures 1 & 2).
Step 2
Drill holes using a 8mm drill. Insert the supplied
rawlplugs (see figure 3). If mounting on to a cavity wall
or ceiling you will need appropriate fixings (not
supplied).
Step 3
Screw the mounting bracket to the wall using the
supplied screws (figure 4).
Step 4
Fit the panel to the wall by locating all four mounting
fixings on the rear of the panel into the wide openings
on the mounting bracket. Once in position the panel
should be moved to the right and then down and to the
right again to its secure position (portrait mounting) or
down, then left and then down again (landscape
mounting) (fig 5 & 6).
Step 5 (Mirrors & Glass panels only)
Unscrew the four distance pieces (in each corner) on the rear of the heater panel so that the panel is held
tightly in its mounting on the wall and cannot be moved. Ensure the power lead is free from any obstruction
behind the panel.
Removal
Herschel Easy-fix is designed to be secure to avoid accidental dismounting or tampering with the panel. To
dismount the panel, screw the four distance pieces back in and move the panel to the left, then up and
over to the left again (portrait mounting) or up, then to the right and then up again (landscape mounting).
NOTE: If mounting larger panels (600w upwards) to a ceiling, use suitably rated fixing screws/mechanism
for the weight of the panel. Use the additional 2 fixing holes on the Easy-Fix mounting plate and fix to a
joist wherever possible. 2 people may be needed to mount the larger panels.
Assembly Kit
Please check the enclosed assembly kit consists of:
1 x mounting bracket,
4x screws,
4x rawlplugs
IMPORTANT
Glass and mirror panels are not designed for ceiling
mounting and there is a risk of overheating and glass
shattering or shortening of the panel lifespan. Do not
ceiling mount glass or mirror panels.
Select XLS
ENGLISH