T&S B-7000 Serie Manual Del Usuario página 6

General Instructions
Installation Installation
General Mounting Requirements
• (Fig. 2) Main-shaft must be horizontal.
• (Fig. 3a) Swivel inlet must be connected with fl exible hose. Rigid pipe may cause
premature wear and affect performance.
• (Fig. 3b) Centerline of spool assembly must be in-line with hose pull out. To adjust
guide arm, remove screws holding it to base and rotate to desired group of mount-
ing holes.
• Qualifi ed personnel must evaluate wall or ceiling fastening. Mounting through the
(4) 1/2" dia. holes on the base may vary due to surface materials. A possible
method for concrete, brick and cement block is a sleeve anchor type stud fastener
(fi g. 4) instead of, sometimes diffi cult to install, long lag bolts.
Fig. 1
Fig. 3a
Fig. 2
Fig. 3b
Fig. 4
6