Acquisition Procedure - Roger B70/2ML Instrucciones Y Advertencias Para El Instalador

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 142
TEST
CLOSE
10.2

Acquisition procedure:

PROG
AP P-
x4 s
1 click
x2 s
AU to
AU
to
AU to
• Press PROG again. Auto is shown on the display.
• MOTOR 1 starts opening at low speed.
• After the delay time set with parameter
2 s.
When the message
set with parameter
(default setting 5 s), MOTOR 1 closes until the gate closed mechanical stop is reached.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display
mode.
acquisition error. Press the TEST button to clear the error, and check the safety device in alarm state.
travel length error. Press TEST to clear the error, and check that both gate leaves are fully closed before
launching a new acquisition procedure.
For more information, see chapter 14 "Alarms and faults".
27
No
da
ta
No
Yes
00
PROG
AU to
2
MOTOR 2
PARAM. 26
CLOSING
DELAY TIME
(with a default time setting of 3 s), MOTOR 2 starts an opening manoeuvre.
TEST
SEE CHAPTER 14 e 15
1 click
TEST
PROG
1 click
Press and hold on
TEST
ACQUISITION
PROCEDURE
CHAP. 11.2
1 click
1
MOTOR 1
PARAM. 25
OPENING
DELAY TIME
2
1
MOTOR 1
CLOSE
CLOSING
Until...
ACQUISITION
PROCEDURE
AP P-
CHAP. 11.2
2
1
MOTOR 2
OPEN
OPENING
Yes
61

Publicidad

Tabla de contenido
loading

Tabla de contenido