Switching The Device On; Important; Setting The Temperature; Automatic Switch-Off - Beurer HK 70 Instrucciones De Uso

5.3 Switching the device on

To switch on the heat pad, press and hold the ON/OFF button (6). The ON/OFF button will light up red.
Temperature setting 3 – maximum heat – is active.
NOTE
Depending on the make, the 12-V socket in the vehicle may be activated at different times:
• permanently
• after opening the vehicle
• depending on the ignition or on whether the engine is running

IMPORTANT

If the 12-V socket in the car is permanently activated, we recommend always disconnecting the car
adapter from the 12-V socket when leaving the vehicle.

5.4 Setting the temperature

To change the temperature, briefly press the ON/OFF button. The switching sequence is 1-2-3-1-2 ...
Setting 0: OFF
Setting 1: Minimum heat – lights up green
Setting 2: Medium heat – lights up yellow
Setting 3: Maximum heat – lights up red
NOTE
The fastest way to warm up the heat pad is to initially set the highest temperature setting.
NOTE
This heat pad has a fast heating function, which allows the heat pad to warm up quickly
in the first 10 minutes.
WARNING
If the heat pad is being used over several hours, we recommend that you
set the lowest temperature setting on the controller to avoid overheating
the heated body part, which may lead to burns to the skin.

5.5 Automatic switch-off

This heat pad is equipped with an automatic switch-off function. This turns off the heat supply
approx. 90 minutes after the initial use of the heat pad. The ON/OFF button is then no longer
illuminated. You can switch the heat pad on again by pressing the ON/OFF button.

5.6 Switching the device off

To switch off the heat pad, press and hold the ON/OFF button. The ON/OFF button is then no longer illu-
minated.
NOTE
If the heat pad is not being used, press and hold the ON/OFF button to switch off the heat pad, and
pull the mains part from the socket or the car adapter from the 12-V socket in the car.
17
90
min
STOP