Pairing The Heat Link And Thermostat - SPC HESTIA Manual De Usuario

4. PAIRING THE HEAT LINK AND
THERMOSTAT
With the thermostat in Standby mode, press the On/Off button
for 3 seconds until "RF2" is shown on the display. Then press
the same button briefly and the display will show the message
"---". EN
O 1 MODO 2
MODO 2
While the display is showing this message, with the heat
link turned off, keep the control button pressed for around 3
seconds. Then it will light up in yellow.
If the pairing has been successful, a "1" will be shown on the
display and a icon will stop flashing. If it has not been
successful, it will go back into Standby mode after 10 seconds
and the icon will flash.
31