Publicidad
Idiomas disponibles
Idiomas disponibles
A. Hardware Installation
There are two ways to install the Adapter:
1.
Plug the Adapter directly to the USB port on your computer.
2.
Connect the Adapter and your computer through the USB cable attached in package.
The LED will light up when the Adapter is installed successfully and the PC is on.
B. Software Installation for Windows® XP
1.
Insert the Resource CD into your CD-ROM drive. Double-click My Computer, and
then double-click the CD/DVD drive where the installation CD was placed. Open
APPUSB300 folder, and double-click Setup.exe. Then you will see Figure 1.
2.
Follow the step-by-step instructions in the continued prompted screens to complete
InstallShield Wizard steps.
Note:
1)
If Windows® XP warns about Windows® Logo testing, click Continue Anyway to
continue the installation.
2)
After the Installation,
tray. Otherwise, there may be some problems about the installation, please check it
seriously.
C. Configure wireless connection in Windows® XP with APPUSB300
Wireless N Client Utility
The Adapter's tray icon
strength indication (RSSI). If the icon is
established. If the icon is
launch a wireless connection manually.
Figure 1
or
will appear at the bottom of the screen in your system
shows the signal strength using color and the received signal
(gray), there is no connection. Follow the steps below to
(green), a wireless connection has been
9
Publicidad
