Before Use - EVA EVAstream FIT Instrucciones De Seguridad

Using the EVAstream safely

Before use

•
Every user and operator of the EVAstream must read the operating instructions in full, in advance. The regulations
must be followed carefully at all times.
•
The machine may only be operated under water. The machine must always be fully submerged before use. Serious
and permanent damage to the machine can occur if the EVAstream is not submerged during use.
•
The water and surroundings must meet the environmental conditions as further described on the last page of this
document.
•
Installation depth: the EVAstream can be placed a maximum of 50 cm below the water level.
•
The machine and the basin in which it is placed must be free of obstacles before turning on the machine. Small
objects and toys must be removed from the water and from the bottom to avoid damage to the machine.
•
The EVAstream is only intended to be used as a counter-current swimming machine. Use for any other purpose must
be discussed with the manufacturer in advance and must be documented in writing.
•
For safety reasons, it is not allowed to mount lights other than EVA Optic to the EVAstream motor control unit.
•
Make sure that EVAstream users always read these instructions before use. Store these operating instructions in an
easily accessible place near the machine.
Rules for safe use
•
The EVAstream is equipped with a plug. When permanently connected to 230V mains, the installer must install a
main switch/isolation switch in the room in which the EVAstream machine is used. This switch is used to switch the
machine on and off. For your safety, and the safety of other users, use this switch to turn the machine on right
before use and turn it off immediately after use.
•
Standard swim caps are included with the EVAstream. We expressly point out that it is mandatory for every
swimming pool user to use a swim cap when the EVAstream is switched on.
•
Make sure that toys and small parts have been removed from the water and the bottom of the pool before
switching on the EVAstream.
•
Make sure that there are no people in the suction and outflow area of the turbine swimming installation before
turning on the turbine.
•
When operating the EVAstream, always ensure that the machine and pool in which it is located are in sight.
•
The suction of water takes place around the machine. Always make sure that the suction parts are completely free
of obstacles. These parts of the machine must not be closed or blocked in any way. This not only provides an
adequate supply of water, but it also ensures that the suction power always remains within the required levels (EN
13451-1/3).
•
Always keep a sufficient distance from the EVAstream for your safety. Sufficient distance is at least 50 cm on both
the front and the sides (for surface-mounted version).
•
Consider the force of the flow when using the EVAstream. Adjust the speed to the strength and skill of the user.
•
With the surface-mounted version, ensure that no people stand, sit, or otherwise place weight on the machine.
EVA Tech B.V. | De Velde 1, 8064 PH Zwartsluis, Netherlands | +31 (0)38 - 33 75 067 | www.evastream.nl
5
V22.1-NL