Descargar Imprimir esta página

Craftsman ZTS 7500 Manual Del Operador página 25

Ocultar thumbs Ver también para ZTS 7500:

Publicidad

Idiomas disponibles

Idiomas disponibles

CHECK ENGINE OIL LEVEL -
BRIGGS & STRATTON
MODELS
Service Interval:
Before each use, and every 8 hours.
1. Turn the engine off, and set the parking brake to
PARK.
2. Clean the area around the dip stick (C, Figure 29).
3. Remove the dip stick (C) and clean it with a paper
towel.
4.
5.
Insert the dip stick back into the engine. Thread the
cap back onto the tube (D).
Remove the dip stick and read the oil level. The oil
level should be between the "FULl" and "ADD" marks
(D). If not, add oil according to the oil recommenda-
tions chart (Figure 28).
CHANGE
ENGINE OIL -
BRIGGS & STRATTON
MODELS
Service Interval:
50 hours or once per season.
Oil Capacity:
1-7/8 quarts (1.8L) without filter change.
NOTE: Change engine oil while the engine b warm. Run
the engine for a few minutes, then shut the engine off
and allow it to cool from hot to warm.
1. Clean the area around the dip stick (C, Figure 29)
and oil drain tube (A).
2. Remove the oil drain plug (A) from the end of the oil
drain tube. Remove the dip stick (C). Allow ample
time for complete drainage.
3. Reinstall the oil drain plug (A) and route the hose
next to the engine.
4. Fill the crankcase with oil. See CHECK ENGINE OIL
LEVEL above.
CHANGE
ENGINE OIL & FILTER
BRIGGS & STRATTON
MODELS
Service interval: t00 hours or once per season.
Oil Capacity:
2 quarts (1.9L) with oil filter change.
NOTE: Change engine oil while the engine is warm. Run
the engine for a few minutes, then shut the engine off
and allow it to cool from hot to warm.
t. Clean the area around the dip stick (C, Figure 29)
and oil drain (A).
2. Remove the oil drain plug (A) and and dip stick (C).
Allow ample time for complete drainage.
3. Remove the oil filter (B). Discard the filter.
4. Using a drop of oil on your finger tip, wet the rubber
gasket on the bottom of the new filter.
Useoil classifiedAPI Service Class SF,
SG, SH, SJ or betterwith SAEViscosity:
v
I
I
i
--
°F
-20
0
20 32 40
60
80
100
°C
-30
-18
-7
o
4
16
27
38
*CAUTION: Air cooled engines run hotter than automotive engines.
Tile use of non-synthetic multi-viscosity oils (5W-30, 10W-30, etc.)
in temperatures above 400 F(4°C) will result in higher than normal
oil consumption. When using a mtdti-viscosity oil, check oil level
more frequently.
**CAUTION: SAE 30 oil, if used below 400F (4°0), will result in hard
starting and possible engine bore damage due to inadequate
lubrication.
Figure 28. Recommended
Engine Oil -
Briggs & Stratton
Models
Figure 29. Oil Change =Briggs
& Stratton
Models
A. Oil Drain Tube
B. Oil Filter
C. Dip Stick
D. Checking Oil Level
6. Turn the filter clockwise until the rubber gasket meets
the filter base. Then turn 1/2 to 3/4 turn more.
7. Reinstall the oil drain plug (A).
8. Fill the crankcase with oil. See CHECK ENGINE OIL
LEVEL above.
9. Test run the engine to check for leaks. Stop the
engine for 1 minute, then recheck the oil level.
25

Publicidad

loading

Este manual también es adecuado para:

107.27772107.27774