Tabla de contenido
Publicidad
To work with the Editor, do the following:
After switching on the unit, look for an unused instrument
program i.e. „INSTRUMENT____10". There you search the
option "PIANYZER" using the "note" keys"
After pressing the key "E", keep the die „S" button pressed while
at the same time tapping "F" button, to skip the write protection.
Select the option „EDITOR" using the "func" keys and press „E"
again.
Select the highest tone of your piano which has a 2 string chorus
and press "E".
Select the highest tone of your piano which has a 1 string chorus
and press "E".
Play the note "a-1" to measure the concert pitch of your
instrument and use the "Func" buttons to align the tuner. (See
also capter 2.6 of the manual) or you already can tune the chorus
of "a-1" to your desired pitch.
By pressing the "E " you are starting to enter the cents of the
"support notes.
Using the „Func" keys, you enter the Cents of the „support-note"
which is predefined by the tuner. With the „E"or „< Note" key you
may switch to the next „support-note". With „Note >" key you can
back step.
If you have entered the cents for all the "support-notes" , you will
get i.e. the following indicator.
Press "E". The device calculates the piano stretching and stores
them. To start with the real work of piano tuning, search the function
"tune" with the "note" buttons. Then it goes on, as described in
Section 3.5 of the manual for CTS-7.
3.10.3 Diagram of an PIANYZER stretching
... see next page.
19
TUNE
->110
INSTRUMENT____10
PIANYZER
->110
INSTRUMENT____10
SELECT
A10
EDITOR
<>
_d__
<>
S10
2-STRING CHOIR
_G#_
<>
S10
1-STRING CHOIR
_a_1
K10
440.00
_a_2
3.0
E10
SUPPORT-NOTE
-26 -16
-8
-2
0
3
11
36
TUNE
->110
INSTRUMENT
10
6
Publicidad
Tabla de contenido
