Assembly - Craftsman 580.752441 Manual Del Operador

Your pressure washer requires some assembly and is
ready for use only after it has been properly serviced
with the recommended oil and fuel.
If you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
UNPACK THE PRESSURE WASHER
1. Remove everything from carton except pressure
washer.
2. Open carton completely by cutting each corner
from top to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
• Main Unit
• Handle
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting
• Plastic Accessory Tray
• Oil Pouch
• Spray Gun Holder Wireform
• Parts Bag (which includes the following):
• Operator's Manual
• Bag containing 4 Multi–Colored Spray Tips
• Handle Fastening Hardware Kit (which
includes):
• Carriage Bolts (2)
• Plastic Knobs (3)
• Tree Clips (4)
Become familiar with each piece before assembling
the pressure washer. Identify all contents with the
illustration on page 6. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly
before operation:
1. Attach handle and accessory tray to main unit.
2. Add oil to engine crankcase.
3. Add fuel to fuel tank.
4. Connect high pressure hose to spray gun and pump.
5. Connect water supply to pump.
6. Attach nozzle extension to spray gun.
7. Select/attach quick connect spray tip to nozzle
extension.

ASSEMBLY

Attach Handle and Accessory Tray
1. Place handle (A) onto handle supports (B)
connected to main unit. Make sure holes (C) in
handle align with holes (C) on handle supports.
C
NOTICE It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2. Insert carriage bolts (D) through holes from back
of unit and attach a plastic knob (E) from front of
unit. Tighten by hand.
D
3. Place accessory tray (F) over holes (H) on handle
(viewing from front of unit). Push the tree clips
(G) into the holes until they sit flat against the
accessory tray.
4. Insert spray gun holder wireform (J) through hole
on left side of handle (viewing from front of unit).
Hold wireform in place and attach a plastic knob
(K) from inside of unit. Tighten by hand.
J
5. Insert multi–colored spray tips in spaces provided in
accessory tray. See How to Use Accessory Tray.
7
A
C
E
H
G
F
K