Snapper 580.752641 Instrucciones De Uso página 13

How to Stop Your Pressure Washer
1. Releasespray gun trigger and let engine idle for two
minutes.
2. Move throttle to SLOW position, then STOPposition.
_i, WARNING Backfire, fire or engine damagecould
occur.
• DO NOT stop engine by moving choke control to "Choke"
position (J",l).
3. ALWAYS point spray gun in a safe direction, press red
button and squeezespray gun trigger to releaseretained
high water pressure.
NOTICE Spray gun traps high water pressure, evenwhen
engine is stopped and water is disconnected.
_i, WARNING The high pressure stream of water that
this equipment produces can cut through skin
and its underlying tissues, leading to serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which can cause
injury.
• Keephigh pressure hoseconnected to pumpand spraygun
whilesystemis pressurized.
• ALWAYSpointspraygun in safedirection,pressred button
andsqueeze sprayguntriggerto release highpressure, e very
time you stop engine.
How to Use PrecisionSpray
TM
Selector
Refer to the PrecisionSpray
TM
Selector instruction sheet for
proper use.
NOTICE Product damagewill occur if the gun trigger is
squeezedwhile the Selector is in-between nozzle settings.
• NEVER turn theSelector whilespraying.
Cleaning and Applying Detergent
_i, CAUTION Chemicals can cause bodily injury, and/or
property damage.
• NEVERuse caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergents/soaps. Follow all
manufacturers instructions.
Toapplydetergentfollowthesesteps:
1. Attach one of the detergent siphon hoses following
instructions Attach Detergent Siphon Hose to Pump.
NOTICE Contact with the hot muffler can damage detergent
siphoning tube.
• When inserting the siphon into a detergent solution bottle, route
the tube so as to keep it from inadvertently contacting the hot
muffler.
2. Prepare detergent solution as required by job.
3. Make sure detergent shut-off valve on cleaning tank is in
"Off" position.
4. If using cleaning tank, pour detergent into cleaning tank.
NOTICE The cleaning tank holds two gallons.
NOTICE Cleaningtank damage may occur if not drained
prior to removing handle.
5. Rotate PrecisionSpray
TM
Selector to a low pressure
position, as described in the PrecisionSpray
TM
Selector
instuction sheet.
NOTICE Detergentcannot be applied with the
PrecisionSpray
TM
Selector in a high pressure position.
6. Make sure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
NOTICE
You must attach all hoses before you start the
engine.
• Starting the engine without all the hoses connected and without
the water turned ON will damage the pump.
• Damageto equipment resulting from failure to follow this
instruction will void warranty.
7. Start engine following instructions How to Start Your
Pressure Washer.
13