Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION! Alcohol-blended fuels (called gasohol, ethanol or
methanol) can attract moisture, which leads to separation and
formation of acids during storage. Acidic gas can damagethe
fuel system of an engine while in storage.
To avoid engine problems, the fuel system should be treated
with a fuel preserver or emptied beforestorage of 30 days or
longer. If adding a fuel preserver, fill the fuel tank with fresh
fuel. If only partially filled, air in the tank will promote fuel
deterioration during storage. If fuel preserver is not used,
drain the fuel tank, start the engineand let it run until the fuel
lines and carburetor are empty. Use fresh fuel next season.See
Storagefor additional information.
NEVERuse engine or carburetor cleaner products in the fuel
tank as permanent damage may occur.
HighAltitude
At altitudes over 5,000 feet (1524 meters), a minimum
85 octane / 85 AKI (89 RON) gasoline is acceptable. To
remain emissions compliant, high altitude adjustment is
required. Operation without this adjustment will cause
decreased performance, increased fuel consumption, and
increased emissions. See a qualified Sears dealer for high
altitude adjustment information. Operation of the engine at
altitudes below 2,500 feet (762 meters) with the high altitude
kit is not recommended.
FreshStart® Fuel Cap
The FreshStart® fuel cap (A) is designed to hold a
cartridge (B) which contains fuel preserver. Adding fuel
preserver helps keep fuel fresh and carburetors clean for
easier starting all season long. The FreshStart® fuel cap, if
equipped with a cartridge, automatically drips concentrated
fuel preserver into your fuel tank so you don't have to add it
_ourself.
Connect Hose and Water Supply to Pump
NOTICE DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment r esultingfrom failureto follow this
instructionwill voidwarranty.
NOTICE
Removeand discard the shipping caps from the
pump's high pressure outlet and water inlet before attaching
hoses.
1.
Uncoil high pressure hose and attach one end of hose to
base of spray gun. Tighten by hand.
%
_ILWABNINGThe
high
pressure stream of water that
this equipment produces can cut through skin
and its underlyingtissues, leading to serious
injuryand possible amputation.
• NEVER connect
high
pressure hoseto nozzle extension.
• Keephigh pressure hoseconnected to pumpand spraygun
whilesystemis pressurized.
• Alwaysbe certainspraygun,nozzles andaccessories a re
correctlyattached.
2.
Attach other end of high pressure hose to high pressure
outlet on pump. Tighten by hand.
NOTICE
FreshStart® fuel preserver cartridge is available as
an optional accessory, retail item 7133386. It is not included
with the pressure washer. Contact the original equipment
manufacturer, retailer, or dealer to obtain a cartridge
designed for the FreshStart® fuel cap installed on this
engine.
Read and follow all instructions and warnings given in the
FreshStart® fuel preserver cartridge package.
Publicidad
