Publicidad
Idiomas disponibles
Idiomas disponibles
,
Insert spray gun holder wireform (A) through hole just
above cleaning tank on right side of handle (viewing
from front of unit). Hold wireform in place and attach a
plastic knob (B) from inside of unit. Tighten by hand.
Add Fuel
Fuel must meet these requirements:
•
Clean,fresh, unleaded gasoline.
•
A minimum of 87 octane/87 AKI (91 RON).High altitude
use, see High Altitude.
•
Gasolinewith up to 10% ethanol (gasohol) or up to 15%
MTBE (methyl tertiary butyl ether) is acceptable.
Attach Detergent Siphon Hose to Pump
The pressure washer is equipped with two detergent
siphoning hoses. One is attached to the cleaning tank and
one is loose for siphoning pressure washer safe detergents
from a bottle or container.
Attach one of the detergent siphon hoses (6) to the barbed
hose fitting (D) on the pump.
NOTICE Only one detergent siphoning hose can be used at
a time. When cleaning tank is not used, make sure detergent
shut-off valve on cleaning tank is in the "Off" position.
Add
Engine
Oil
1.
Place pressure washer on a flat, level surface.
2.
Cleanarea around oil fill and remove yellow oil fill cap.
3.
Using oil funnel (optional), slowly pour contents of
provided oil bottle into oil fill opening (E) to the point of
overflowing.
NOTICE
Improper treatment of pressure washer can
damage it and shorten its life.
• DO NOTattempt to crank or start the engine before it has been
properly serviced with the recommended oil. This may result in an
engine failure.
4.
Replace oil fill cap and fully tighten.
NOTICE Avoid pressure washer damage.
Failureto follow Operator's Manual for fuel
recommendations voids warranty.
• DONOTuseunapproved g asolinesuchas E85.
• DONOTmix oil in gasoline.
• DONOTmodifyengineto run on alternate fuels.
To protect the fuel system from gum formation, mix in a fuel
stabilizer when adding fuel. See Storage. All fuel is not the
same. If you experiencestarting or performance problems
after using fuel, switch to a different fuel provider or change
brands. This engine is certified to operate on gasoline. The
emission control system for this engine is EM (Engine
Modifications).
_i, WARNING
Fuel and its vapors are extremely
flammable and explosive.
Fire or explosion can cause severe burns
or death.
WHENADDING FUEL
• Turn pressure washer OFFand let it cool at least 2 minutes
before removing fuel cap. Loosen cap slowly to relieve pressure
in tank.
• Fill fuel tank outdoors.
• DO NOT overfill tank. Allow spacefor fuel expansion.
• If fuel spills, wait until it evaporatesbefore starting engine.
• Keepfuel away from sparks, open flames, pilot lights, heat, and
other ignition sources.
• DO NOT light a cigarette or smoke.
Cleanarea around fuel fill cap, remove cap.
2.
Slowly add regular unleaded fuel (F) to fuel tank (G). Be
careful not to overfill. Allow about 1.5" (4 cm) (H) of
tank space for fuel expansion.
3.
Install fuel cap and wait for any spilled fuel to evaporate.
Publicidad
