Unpack Thepressure Washer; Carton Contents - Craftsman 580.750700 Instrucciones De Uso

Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problemswith the assembly of your
pressurewasher, please call the pressurewasher helpline
at 1=800-222-3136.
UNPACK THEPRESSURE WASHER
1. Removeeverything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
• Main Unit
• High Pressure Hose
• Spray Gun
• Nozzle Extensionwith Quick Connect Fitting
• Oil Pouch
• Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• Bag containing 3 multi-colored Spray Tips
Become familiar with each piece before assembling the
pressure washer. Identify all contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Fill out and send in registration card.
2. Add oil to engine crankcase.
3. Add fuel to fuel tank.
4. Connect pressure hose to spray gun and pump.
Add EngineOil
1. Place pressure washer on a flat, level surface.
2. Cleanarea around oil fill and remove yellow oil fill
cap/dipstick.
3. Hold neck of supplied oil pouch and remove cap.
4. Slowly pour contents of oil pouch into oil fill opening.
Checkingoil level frequently, fill to FULL mark (top hole)
on dipstick.
Full
NOTICE Pauseto permit oil to settle. Wipe dipstick clean
eachtime oil level is checked. DONOT overfill.
NOTICE Improper treatment of pressure washer could
damage it and shorten its life.
• DO NOT attempt to crank or start the engine before it has been
properly serviced with the recommended oil. This could result in
an engine failure.
5. Replaceoil fill cap/dipstick and fully tighten.
Add Fuel
Fuel must meet these requirements:
• Clean,fresh, unleaded gasoline.
• A minimum of 87 octane/87 AKI (91 RON). For high
altitude use, see High Altitude.
• Gasolinewith up to 10% ethanol (gasohol) is acceptable.
NOTICE Use of unapproved fuels could damage pressure
washer and voids warranty.
• DONOTuseunapproved g asolinesuchas E15and E85.
• DONOT mixoil in gasoline or modifyengine to run onalternate fuels.
5. Connect water supply to pump.
6. Attach nozzle extension to spray gun.
7. Select!attach quick connect spray tip to nozzle extension.