Installing Or Removing Hedge Shear Blades - Makita DUM168 Manual De Instrucciones

1. Hedge shear blade
2. Hedge shear blade cover
3. Storage case
011044
Chip receiver for hedge trimming (for Hedge
•
Trimmer)
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.

Installing or removing hedge shear blades

CAUTION:
Before installing or removing shear blades, always
•
be sure that the tool is switched off and the battery
cartridge is removed.
When replacing the shear blades, always wear
•
gloves without removing blade cover so that hands
and face do not directly contact the blade. Failure
to do so may cause personal injury.
NOTE:
Do not wipe off grease from the gear and crank.
•
Failure to do so may cause damage to the tool.
For specific way of removing and installing shear
•
blades refer to the reverse of a package for
accessory shear blades.
Installing the hedge shear blades
1
2
012561
Prepare the crank, the undercover and new shear
blades.
1
1. Crank
2. Undercover
3. Shear blades
3
2
1
1. Basic alignment line on the tool housing
2. Pins
010905
Adjust the three pin position so that these three pins are
aligned with the basic alignment line on the tool housing.
1. Recessed part of crank
2. Crank
3. Apply grease
4. Pins
015776
Fit the crank with its recessed part facing downward onto
the pins. At this time, apply a small amount of grease to
the periphery of the crank using grease that the shear
blades as optional accessory are provided with or that
14
3
2
1
2
3
4