Connect Hose And Water Supply To Pump - Craftsman 580.752290 Instrucciones De Uso

Toprotect thefuel s ystem fromgum formation, mixinafuel
stabilizer when a dding f uel. S ee
Storage. All fuel is not the
same. If you experience starting or performance problems
after using fuel, switch to a different fuel provider or change
brands. This engine is certified to operate on gasoline. The
emission control system for this engine is EM (Engine
Modifications).
WARRIRG
Fueland its vapors are extremely flammable and
explosive.
Fire or explosion can cause severe burns or
death.
WHEN ADDING FUEL
• Turn pressure washer OFFand let it cool at least 2 minutes
before removing fuel cap. Loosen cap slowly to relieve pressure
in tank.
• Fill fuel tank outdoors.
, DO NOT overfill tank. Allow space for fuel expansion.
• If fuel spills, wait until it evaporates before starting engine.
, Keep fuel away from sparks, open flames, pilot lights, heat, and
other ignition sources.
, DO NOT light a cigarette or smoke.
,
2.
Cleanarea around fuel fill cap, remove cap.
Slowly add regular unleaded fuel (A) to fuel tank (B). Be
careful not to overfill. Allow about 1.5" (4 cm) (C) of tank
space for fuel expansion.
3. Install fuel cap and wait for any spilled fuel to evaporate.
CAUTION! Alcohol-blended fuels (called gasohol, ethanol or
methanol) can attract moisture, which leads to separation and
formation of acids during storage. Acidic gas can damagethe
fuel system of an engine while in storage.
To avoid engine problems,the fuel system should be treated
with a fuel preserver or emptied beforestorage of 30 days or
longer. If adding a fuel preserver, fill the fuel tank with fresh
fuel. If only partially filled, air in the tank will promote fuel
deterioration during storage. If fuel preserver is not used,
drain the fuel tank, start the engineand let it run until the fuel
lines and carburetor are empty. Use fresh fuel next season.See
Storagefor additional information.
NEVERuse engine or carburetor cleaner products in the fuel
tank as permanent damage may occur.
HighARRude
At altitudes over 5,000 feet (1524 meters), a minimum
85 octane / 85 AKI (89 RON)gasoline is acceptable. To
remain emissions compliant, high altitude adjustment is
required. Operationwithout this adjustment will cause
decreasedperformance, increased fuel consumption, and
increased emissions. See a qualified Sears dealer for high
altitude adjustment information. Operation of the engine at
altitudes below 2,500 feet (762 meters) with the high altitude
kit is not recommended.
Connect Hose and Water Supply to Pump
[ ROTICE
DO NOT run the pump without the water supply connected
and turned on.
L amageto equipment r esultingfrom failureto followthis
instructionwill void warranty.
NOTE:Removeand discard the shipping caps from the
pump's high pressure outlet and water inlet before attaching
hoses.
1. Uncoil high pressure hose and attach one end of hose to
base of spray gun. Tighten by hand.
%
WARRIRG
he high pressure stream of water that this
quipment produces can cut through skin and its
nderlying tissues, leading to serious injury and
ossible amputation.
NEVER connecthigh pressurehoseto spraytip extension.
Keephigh pressurehoseconnected to pumpand spraygun
whilesystemis pressurized.
Alwaysbe certainspraygun,spraytips and accessories are
correctlyattached.
2. Attach other end of high pressure hose to high pressure
outlet on pump. Tighten by hand.