Craftsman 580.325650 Manual Del Operador página 6

KNOWYOUROEHERATOR
I!__-!i] Read the Operator'sManual and safety rules before operating your generator.
Compare the illustrations with your generator to familiarize yourself with the locations of various controls and
adjustments. Savethis manual for future reference.
FuelTank Spark Arrestor Muffler
120/240 Volt AC,
/ 30 Amp Receptacle
/
Double Pole Circuit
Breaker (AC)
Data Tag
120 Volt AC, 20 Amp
Duplex Receptacles
Grounding Fastener
Choke Lever
Air Cleaner
Recoil Starter
Engine Rocker Switch
Battery Float ChargerJack
Oil Fill Cap/Dipstick
Start Switch
120 Volt AC, 20 Amp, Duplex Receptacles -- May be used
to supply electrical power for the operation of 120 Volt AC,
20 Amp, single phase, 60 Hz electrical, lighting, appliance,
tool and motor loads.
120/240 Volt AC, 30 Amp LockingReceptacle -- May be
usedto supply electrical power for the operation of
120 and/or 240 Volt AC, 30 Amp, single phase, 60 Hz
electrical, lighting, appliance, tool and motor loads.
Air Cleaner -- Protects engine by filtering dust and debris
out of intake air.
Battery Float Charger Jack -- Use battery float charger to
keep the starting battery charged and readyfor use.
Choke Lever -- Used when starting a cold engine.
Data Tag -- Provides model, revision and serial number of
generator. Pleasehave these readily availablewhen calling
for assistance.
Double Pole Circuit Breaker (AC)-- A double pole circuit
breaker is provided to protect all the receptaclesand
generator against electrical overload.
EngineRocker Switch -- Set this switch to "On"before
starting engine. Set switch to "Off"to stop engine.
Fuel Tank -- Capacity of five (5) U.S. gallons.
GroundingFastener-- Consult your local agency having
jurisdiction for grounding requirements in your area.
Oil Fill Cap/Dipstick -- Checkand fill engine with oil here.
See Oil for oil recommendations and filling instructions.
Recoil Starter -- Used to start the engine.
Spark Arrestor Muffler -- Exhaustmuffler lowers engine
noise and is equipped with a spark arrester screen.
Start Switch -- Push and hold in "Start" position for a
maximum of 15 seconds during each start attempt, until
engine starts.
StatStation
TM
-- Displays the nominal load on generator
based on output frequency. It also has a built in maintenance
reminder.