Radio Reception; Usb Playback - Sony XAV-AX100C2 Manual De Instrucciones

The display does not respond to your touch
correctly.
 Touch one part of the display at a time. If two or
more parts are touched simultaneously, the
display will not operate correctly.
 Calibrate the touch panel of the display (page 14).
 Touch the pressure sensitive panel firmly.
Menu items cannot be selected.
 Unavailable menu items are displayed in gray.

Radio reception

The stations cannot be received.
The sound is hampered by noise.
 The connection is not correct.
– Connect the REM OUT lead (blue/white striped)
or accessory power supply lead (red) to the
power supply lead of a car's antenna (aerial)
booster (only when your car has built-in radio
antenna (aerial) in the rear/side glass).
– Check the connection of the car antenna
(aerial).
– If the auto antenna (aerial) will not extend,
check the connection of the power antenna
(aerial) control lead.
Preset tuning is not possible.
 The broadcast signal is too weak.
RDS
PTY displays [PTY not found.].
 The current station is not a RDS station.
 RDS data has not been received.
 The station does not specify the program type.
Picture
There is no picture/picture noise occurs.
 A connection has not been made correctly.
 Installation is not correct.
– Install the unit at an angle of less than 45° in a
sturdy part of the car.
The picture does not fit in the screen.
 The aspect ratio is fixed on the playback source.
Sound
There is no sound/sound skips/sound cracks.
 A connection has not been made correctly.
 Check the connection between this unit and the
connected equipment and set the input selector
of the equipment to the source corresponding to
this unit.
 Installation is not correct.
– Install the unit at an angle of less than 45° in a
sturdy part of the car.
 The unit is in pause/reverse/fast-forward mode.
20
GB
 The settings for the outputs are not made
correctly.
 The volume is too low.
 The ATT function is activated.
 The format is not supported.
– Check if the format is supported by this unit
(page 17).
Sound is noisy.
 Keep cords and cables away from each other.

USB playback

Items cannot be played via a USB hub.
 Connect USB devices to this unit without a USB
hub.
Items cannot be played.
 Reconnect the USB device.
The USB device takes longer to play.
 The USB device contains large-sized files or files
with a complicated tree structure.
The sound is intermittent.
 The sound may be intermittent at a high-bit-rate.
Audio files cannot be played.
 USB devices formatted with file systems other
than FAT12, FAT16 or FAT32 are unsupported.*
* This unit supports FAT12, FAT16 and FAT32, but some USB
device may not support all of these. For details, refer to the
operating instructions of each USB device or contact the
manufacturer.
The smartphone connected to the USB port
cannot be played.
 The USB connection is only available for Android
phones and USB devices in MSC mode.
When using a smartphone other than an Android
phone, make a BLUETOOTH connection (page 7).
BLUETOOTH function
The other BLUETOOTH device cannot detect this
unit.
 Set [Bluetooth Connection] to [ON] (page 14).
 While connecting to a BLUETOOTH device, this
unit cannot be detected by another device.
Terminate the current connection and search for
this unit from the other device.
 Depending on your smartphone or cellular
phone, you may need to delete this unit from the
history of the connected smartphone or cellular
phone then pair them again (page 7).
Connection is not possible.
 Check the pairing and connection procedures in
the manual of the other device, etc., and perform
the operation again.