Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5. 3 CLEANING AND SANITIZING
PROCEDURES
1 - Cleaning
and
sanitizing
recommended to guarantee the conservation of the best
product taste and the highest unit efficiency. This section
is a procedural guideline only and is subject to the
requirements of the local Health Authorities.
2 - Prior to the disassembly and cleaning, the machine must
be emptied of product. To do this proceed as follows:
- set the power switch to I position
- set mixer/refrigeration switch(es) to I position (Soft Drink
mode)
- place a pail under each faucet and drain all product from
bowls
- set all control switches to the 0 position.
5. 3. 1 DISASSEMBLY
ATTENTION
Before any disassembly and/or cleaning procedure
make sure that the dispenser is disconnected from its
power source.
1 - Remove cover from the bowl.
2 - Remove the bowl by lifting its faucet side up and off the
fastening hooks (see figure 5) and slide it out (see figure
6).
of
the
dispenser
figure 5
are
3 - Slide the outer spiral out (see figure 7) and then the inside
auger. Frequently remove the rear seal by sqeezing it to
break the suction grip (see figure 8).
NHT UL BL
figure 6
figure 7
figure 8
7
Publicidad
Tabla de contenido
