Operating Instructions - Stihl MS 201 T Manual De Instrucciones

English
Open the throttle only when the
chain brake is off. Increased
engine speeds with the chain
brake on (saw chain is stationary)
will quickly damage the clutch and
chain brake.
At very low temperatures
Let the engine warm up briefly with
N
the throttle slightly open
If necessary, configure for winter
N
operation – see "Winter Operation"
Switching off the engine
Move the master control lever to the
N
stop position 0
If the Master Control lever was moved
from the position warm start n to stop 0
– afterwards simultaneously press the
throttle trigger lockout and the throttle
trigger.
If the engine does not start
The master control lever was not
returned from the position cold start l
to warm start n in time, the engine may
be flooded.
Move the master control lever to the
N
stop position 0
Remove the spark plug – see
N
"Spark plug"
Dry spark plug
N
Crank the engine several times with
N
the starter – to clear the combustion
chamber
30
Replace the spark plug – see
N
"Spark plug"
Set the master control lever to warm
N
start n – even if the engine is cold
Restart the engine
N
When the fuel tank has run
completely empty and then been
refueled
Pull the starter rope several times to
N
prime the fuel line
Restart the engine
N

Operating Instructions

During the break-in period
A factory new machine should not be run
at high revs (full throttle off load) for the
first three tank fillings. This avoids
unnecessarily high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
shortblock are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
During work
Do not make the mixture leaner to
achieve an apparent increase in
power – this could damage the
engine – see "Adjusting the
Carburetor".
Open the throttle only when the
chain brake is off. Running the
engine at high revs with the chain
brake engaged (chain locked) will
quickly damage the shortblock
and chain drive (clutch, chain
brake).
Check chain tension frequently
A new saw chain must be retensioned
more frequently than one that has been
in use already for an extended period.
MS 201 T