How To Assemble Your Sprayer; Operation - Swissmex 400195 SP12 Manual De Operador

3.3.2 How to assemble your sprayer:

Following is explained how to assemble your sprayer, read carefully the text. The number at the beginning of the line corresponds to the graphic.
1. Take out all the parts from the box and from inside the tank.
2. Place the sprayer vertically over a table, place the pump holder nut and gasket on the lateral opening. Oil the piston sleeve and the pump tube,
insert it in the pump tube guide; carefully directing the piston sleeve to avoid any damage.Tighten the pump holder nut.
3. Place the strainer and the tank lid on the tank opening.
4. Insert the pump lever behind the back rest and fix it with the "R" pin and washers, to the crank located on the pump shaft . Place the pump handle on the
shaft fixing it with a lock pin.
5. Assemble the spray wand on the shut-off valve. Tighten by hand.
2
4
5

OPERATION

4.
Use always the strainer when filling the tank up with liquid.
Mix solution in a separate receptacle, following manufacturer's directions on the container.
Pour pre-mixed solution into sprayer and cap.
Place the sprayer on back and pressurize tank by pumping 20 times approx.
You will need to pump once each 3 or 4 seconds to maintain the desired spraying pressure.
For a continuous spraying, fix the shut-off valve lever.
Move the nozzle cap to change the spray pattern.
3
OIL PUMP TUBE AND PISTON SLEEVE BEFORE ASSEMBLING
ATTENTION
3
IN THE SPRAYER
NOTE:
To ensure good performance use original
"SWISSMEX-RAPID" spare parts.