Troubleshooting - Premier SX-4659DSD Manual De Instrucciones

Troubleshooting

Before resorting to maintenance service, please kindly check by yourself
with the following chart.
Symptom
No Power The AC power cord is not connected to
the power supply or is not connected to a
power supply securely.
Picture Video input mode of the connected TV
There is no picture
isn't correctly set.
or the picture is
Video output mode of this unit isn't
distorted.
correctly set.
Sound The audio cables aren't connected
There is no sound securely.
or the sound is The volume is set at the lowest level.
distorted. The sound is switched off.
The disc is in fast forward/rewind
playback.
Unable to play a This disc is placed in the disc tray in a
disc wrong way.
The rating of the disc is higher than the
rate set in the parental control item.
The unit isn't compatible with the disc.
The disc is dirty.
The player The connected USB drive or the
breaks down memory card is probably not of a
when a USB certified one.
drive ormemory
card is inserted
into the player.
The unit is being interfered with static
The buttons on
electricity etc.
the unit doesn't
work.
There is no battery in the remote control.
The remote The batteries are out of charge.
control does not The remote control isn't pointed to the
function. remote sensor.
The remote control is out of its working
area.
The unit is shut down.
Cause(s)
Please check that the AC power cord
is connected securely.
Set an appropriate video output
mode.Press [V-MODE] repeatedly until
the picture becomes normal again.
Connect the video cable securely.
Connect the audio cables securely.
Turn up the volume.
Press [MUTE] on the remote control
to switch on the sound.
Press [PLAY/PAUSE].
Check that the disc is placed in the
disc tray with its label side upwards.
Reset the settings in the parental
controlitem.
/
Clean the disc.
The player cannot play any uncertified
USB driveand memory card.In case the
player breaks down, turn it off,
disconnect the power cord from the AC
outlet and unplug the USB drive or /and
the memory card from the player. Then,
power on the player again. The player
will resume thenormal status.
Switch off and unplug the player.
Then connect the plug to the power
supply and switch it on again.
Install two AAA/1.5V batteries in it.
Replace the batteries with new ones.
Make sure that the remote control is
pointed to the remote control sensor.
Make sure the remote control is
within the working area.
Switch off the unit and disconnect it
from the AC outlet. Then power on the
unit again.
Remedy
Page 21