Adjusting The Microphone Angle; Installing The Tv Aerial; Assembling The Tv Aerial; Mounting The Tv Aerial - Pioneer AVH-Z7050TV Manual De Instrucciones

Adjusting the microphone
angle

Installing the TV aerial

Z7050TV
CAUTION
This TV aerial is dedicated for inside of the
vehicle. Do not install it outside of the
vehicle.
Assembling the TV
aerial
1
Screw the rod to the aerial
Aerial
Rod

Mounting the TV aerial

1
Check the installation location.
2
Remove the sheet from the back of TV
aerial, and attach the TV aerial to the
windscreen.
NOTES
• Wipe the humidity, dust, dirt and oil from
the installation location.
• Attach the TV aerial within the following
allowable area.
Allowable area for installation
Windscreen with ceramic line
Windscreen without ceramic line
Allowable area for installation: Within 25
mm
Windscreen

Appendix

Troubleshooting

If you have problems operating this
product, refer to this section. The most
common problems are listed below, along
with likely causes and solutions. If a
solution to your problem cannot be found
here, contact your dealer or the nearest
authorised Pioneer service facility.
Common problems
A black screen is displayed, and
operation is not possible using the touch
panel keys.
→ [Power OFF] mode is on.
– Press any button on this product to
release the mode.
Problems with the AV screen
CD or DVD playback is not possible.
→ The disc is inserted upside down.
– Insert the disc with the label upward.
→ The disc is dirty.
– Clean the disc.
→ The disc is cracked or otherwise
damaged.
– Insert a normal, round disc.
→ The files on the disc are in an irregular
file format.
– Check the file format.
→ The disc format cannot be played back.
– Replace the disc.
→ The loaded disc is a type this product
cannot play.
– Check what type of disc it is.
The screen is covered by a caution
message and the video cannot be shown.
→ The handbrake lead is not connected or
the handbrake is not applied.
– Connect the handbrake lead correctly,
and apply the handbrake.
→ The handbrake interlock is activated.
– Park your vehicle in a safe place and
apply the handbrake.
No video output from the connected
equipment.
→ The [AV Input] or [AUX Input] setting is
incorrect.
– Correct the settings.
The audio or video skips.
→ This product is not firmly secured.
– Secure this product firmly.
No sounds are produced. The volume
level will not rise.
→ Cables are not connected correctly.
– Connect the cables correctly.
→ The system is performing still, slow
motion, or frame-by-frame playback
with DVD-Video.
– There is no sound during still, slow
motion, or frame-by-frame playback
with DVD-Video.
→ The system is paused or performing fast
reverse or forwards during the disc
playback.
– For the media other than music CD
(CD-DA), there is no sound on fast
reverse or forwards.
The icon is displayed, and operation is
impossible.
→ The operation is not compatible with
the video configuration.
En
63