Manual Clock Adjustment; Dsi (Disabled System Indicator); Dimmer; Switching Preout - Kenwood KDC-MP2035 Manual De Instrucciones

Menu system
In Standby mode

Manual Clock Adjustment

1
Select Clock Adjustment mode
Push the Control knob towards [FM] or [AM].
Select the "CLK ADJ" display.
2
Enter Clock Adjust mode
Press the Control knob for at least 1 second.
The clock display blinks.
3
Adjust the hours
Push the Control knob towards [FM] or [AM].
Adjust the minutes
Push the Control knob towards [4] or [¢].
4
Exit Clock adjustment mode
Press the [MENU] button.
In Standby mode

DSI (Disabled System Indicator)

A red indicator will blink on the unit after the
faceplate is removed, warning potential thieves.
Display Setting
"DSI ON" LED flashes.
"DSI OFF" LED OFF.

Dimmer

You can lower the brightness of the display by using
the dimmer function.
Display Setting
"DIM ON" The display dims.
"DIM OFF" The display doesn't dim.
Function of KDC-MP2035/KDC-MP235/KDC-MP205
In Standby mode

Switching preout

Alternating the preout between the rear and
subwoofer. (With the subwoofer the sound outputs
without being effected by fader control.)
20
|
English
Display Setting
"SWPRE R" Rear preout.
"SWPRE SW" Subwoofer preout.
In Audio file source

Supreme Setting

When MP3 or WMA files encoded at a low bit rate
(less than 96kbps (fs=32k, 44.1k, 48kHz)) are played,
this function restores their high frequency region
to approach the sound quality of equivalents of
these files encoded at a high bit rate. Processing is
optimized for the compression format used (MP3, or
WMA), and adjustment is made for the bit rate used.
Display Setting
"SPRM ON" Plays sound using the Supreme function.
"SPRM OFF" Plays the original sound stored in the audio file.
⁄
• The sound effect may be imperceptible depending
on the relationship between the audio file format and
setting.
In FM reception

CRSC (Clean Reception System Circuit)

Temporarily have reception alternate from stereo to
mono to reduce multi-path noise when listening to
the FM station.
Display
"CRSC ON"
"CRSC OFF"
⁄
• Strong electrical fields (such as from power lines) may
cause unstable sound quality when CRSC is turned ON.
In such a situation, turn it OFF.
Setting
The CRSC is ON.
The CRSC is OFF.