Publicidad
①
②
⑤
26
English
WARNING:
about this system. The Emergency Tab may not always be an effective
measure to securely remove cheekpads depending on circumstances of
accident or condition of injured wearers.
TO REMOVE/REPLACE COMFORT LINING
The comfort lining is secured to the helmet by plastic bosses ①.
③
To remove the lining, undo bosses by grasping the lining as close to each
boss as possible ② and pulling straight up ③. Note the fore & back, top &
bottom sides of the lining for replacement.
NOTE:
removable to offer a bit more room if desired. Gently remove it from the
④
pad. Once removed this foam layer will not reattache securely ④.
To wash the comfort lining, put it into lukewarm water with small amount of
laundry soap or your own shampoo and wash gently by hand. Rinse well with fresh
water and wipe off with a soft cloth. Dry it in the shade at ambient temperature.
WARNING: Never use petrol, thinner, benzene or any other solvents.
⑥
To replace the lining, place the bosses over their plastic receptacles and push
them home ⑤& ⑥.
WARNING:
properly positioned along the inside shape of the EPS (a.k.a. Styrofoam)
liner. If the comfort lining is not properly installed, the frame of the
comfort lining may fold when you put on and take off the helmet, which
may injure your skin, etc. Whenever you feel something is wrong with the
comfort lining, check that the lining is properly installed.
Rescuers need to have sufficient knowledge and training
The lining is equipped with a 5mm surface foam layer. The layer is
When reinstalling the comfort lining, be sure the lining is
Publicidad
Capítulos
