Mitsubishi Electric PAR-CT01MAA-PB Manual De Instalación página 16

Button operations on the Main menu
Cursor
F1
8 Turning on the power
Make sure that the MA remote controller is properly installed according to the instructions in the
Installation Manual and that the indoor and outdoor unit installation has been completed before
turning on the power.
(1) When the power is turned on, the following screen will appear.
Normal start up (indicating the
percentage of process completion)
(2) Main display
After the successful startup, the Status display will appear. While the Status display is displayed,
pressing any area switches the screen to the Main display. The Main display can be displayed in
two different modes: "Full" and "Basic." Refer to section 10 "Initial settings" for how to select the
display mode. (The factory setting is "Full.")
Main display in the Full mode
(while the unit is not in operation)
F2 F3 F4
Note: When the power is on for the first time, the Language selection screen
will be displayed. Refer to section 10 (4) under "Display setting menu".
Select a desired language. The system will not start-up without language
selection.
Main display in the Full mode
(while the unit is in operation)
– 16 –
Move the cursor to the desired function with the F2
and F3 buttons, and press the SELECT button to go
to the next page. Password may be required.
Button function guide will appear at the bottom of the
screens.
Note: Refer to the Instruction Book for the
icons on the display.