Avanti DG2450SS Manual De Instrucciones página 23

REPLACING THE OVEN LIGHT
•
Let the oven cavity and broil burner cool down.
•
Switch off the electric supply.
•
Remove the protective cover.
•
Unscrew and replace the bulb with a new one suitable for high temperature (200°~ 500°F) having
the same specifications: 120V 60Hz, 15W, E14.
•
Replace the protective cover.
NOTE: Oven bulb replacement is not covered by your guarantee.
LEVELING THE RANGE
The range must be level to obtain proper operating. The four screws type leveling legs located on the
corners at the bottom of range should be adjusted by turning them clockwise to make the range
higher or counter-clockwise to lower the range until the range is level. Use a level on surface units to
check the leveling of the range.
ANTI-TIP BRACKET INSALLATION
To reduce the risk of tipping the range by abnormal usage or improper door loading, the range must
be secured by properly installing the anti-tip device packed with the appliance.
•
Place the anti-tip bracket on the floor as shown figure. Anti-tip bracket can be installed on either
right or left side.
•
Make the locations of 2 holes of ant-tip bracket on the floor.
•
Use a 5/16" masonry drill bit and insert plastic anchor.
•
Secure bracket to floor using screws supplied.
•
Slide appliance into position.
NOTE: If range is relocated, the bracket must be removed and installed in new location.
Install the anti-tip bracket either right or left side.
The contour line of back panel of appliance
The contour line of front panel of appliance
1.30"
Anti-tip
Bracket
Move the appliance to the final position.
23
Anti-tip Bracket