Fiamma CARRY-BIKE 200 DJ DUCATO Instruciones De Montaje Y Uso página 22

Gebrauchsanweisungen und Ratschläge
DE
FR Instructions et conseils
IT
Avvertenze e suggerimenti
- The FIAMMA Carry-Bike 200 DJ Ducato is a bicycle carrier specially designed for Ducato vehicle
(> 06 2006). It is supplied with Bike-Block Pro blocking system and 2 Rail Premium, it is
delivered as standard for transporting 2 bicycles.
- Fasten the Carry-Bike to the rear bearing structure of the vehicle.
- Because it is overhanging structure posteriorly installed, this overhang must be regulated according
to the regulations in force. After setting of Carry-Bike on rear axis of the vehicle, normal weight's
distribution on two axis could be modifi ed; be sure that it doesn't exceed the maximum
permissible load (verify the data on your own logbook).
All-up weight of the vehicle has to be always verifi ed in proper equipped area.
- We recommend that the area where the bicycle rack will be mounted be cleaned before installation.
- To avoid excess abrasions on the vehicle's paint, before use check all points that may risk being
rubbed when the door is opened (they could be caused by the vehicle's construction tolerances).
- Make sure that the luggage compartment is always closed.
- Make sure that the support brackets are located where they cannot move or shift sideways.
They also must not touch the roof of the vehicle, the hinges and the corresponding bolts or screws.
- Periodically check the bicycle rack to make sure it is fi rmly attached, especially after the fi rst 10 km.
Make sure the belts are not loose and that the holding brackets have not shifted.
- Make sure that fastening is secure: during each trip, stop and check that the bicycles are securely
fastened after the fi rst short run.
- DO NOT COVER THE NUMBER PLATE OR LIGHTS.
Repeat lights and plate by using a trailer board if the Carry-Bike covers them, even partially.
- Do not hide Carry-Bike with covers. Detachable parts like child safety seats, bags or air
compressor have to be uncoupled and put away inside the vehicle. Bicycles have to be fi xed
both with two Quick-Safe (one piece per wheel) and Security Strip (Bike-Block) on the frame.
Both Quick-Safe and Security Strip have to be periodically checked. In case of damage, they
have to be immediately replaced. While fi xing the bikes, verify that there is enough distance
between handlebars and/or pedals and vehicle's wall, to avoid to compromise the paintwork.
- In the case of a long period of disuse, we suggest that you unhook the bike carrier.
- The load must be evenly distributed and must not exceed the maximum width of the vehicle.
- Be careful when driving and beware of gusts of wind. Also keep in mind that you need a longer
braking distance. Pay attention to dangerous road crossing and garage's entrance.
Addition rearview mirrors are required in case of reduced visibility.
- In some cases, the bicycle rack interferes with using the rear windscreen wiper.
Carefully examine the brush radius before turning on the rear wiper.
- IN CASE OF USE OF THE BIKE CARRIER WITH TOW MAKE SURE THAT THE TOW HOOK IS
ALWAYS ACCESSIBLE AND THE CORNER MOBILITY OF THE TOW IS GUARANTEED (VOLUME
MEASURING DIN 74058).
- FIAMMA is not liable for damages arising from non-observance of the laws in force, the installation,
carriage and maintenance instructions or from incorrect use of the bike carrier.
22
EN
ES
Carry-Bike
Maintenance instructions
Recomendaciones