cecotec Conga 5090 Cyclone Manual De Instrucciones página 34

Recommendation: Remove the Wet & dry tank during charge.
5.2. REMOTE CONTROL
1
2
3
Remote control binding
If the robot does not respond to the remote control, follow the below steps:
1. Press the edge mode button on the remote control for 5 seconds for the remote
control to enter pairing mode. The screen will display 8888.
2. The remote receiver will be activated in 5 seconds and will enter pairing mode. The
remote control's signal is received and the remote control returns to normal status. The
display will show pairing is completed.
3. If the pairing process is unsuccessful, the remote control will display 8888 and will
exit the pairing mode after 30 seconds.
The following operations and modes can be activated from the remote control:
Modes
The first time the robot is operated, it will map and save the whole house's map by means of its
laser before starting the cleaning cycle. Use the robot in auto mode and eco power level, this
way you will ensure the robot memorizes the map 100 %.
Note: Make sure the light indicator is lighted in blue before starting cleaning, indicating it is
activated. If it is not, press any button on the remote control to wake it up.
1. Auto mode
Press on the remote control for it to start cleaning automatically, first a cleaning cycle in
1. Schedule
4
2. Power levels (Turbo/Normal/Eco)
3. Back home
5
4. Time
6
5. Manual control
7
6. On/Pause
7. Edge mode
ENGLISH
35