Technical Specifications; Disposal Of Old Electrical Appliances; Technical Support Service And Warranty - cecotec Conga 5090 Cyclone Manual De Instrucciones

The robot does not resume
cleaning .
The robot is always offline.
Connection between the
mobile phone and the robot
failed.

10. TECHNICAL SPECIFICATIONS

Product: Conga 5090
Reference: 05424
100-240 V~ 50/60 Hz
Battery: 14,8 V, 6400 mAh
Made in China | Designed in Spain

11. DISPOSAL OF OLD ELECTRICAL APPLIANCES

The European directive 2012/19/EU on Waste Electrical and Electronic Equipment
(WEEE), specifies that old household electrical appliances must not be disposed of with
the normal unsorted municipal waste. Old appliances must be collected separately, in
order to optimize the recovery and recycling of the materials they contain, and reduce
the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation to dispose
of the appliance correctly. If the product has a built-in battery or uses batteries, they should be
removed from the appliance and disposed of appropriately.
Consumers must contact their local authorities or retailer for information concerning the
correct disposal of old appliances and/or their batteries.

12. TECHNICAL SUPPORT SERVICE AND WARRANTY

This product is under warranty for 2 years from the date of purchase, as long as the proof
of purchase is submitted, the product is in perfect physical condition, and it has been given
proper use, as explained in this instruction manual.
The warranty will not cover the following situations:
• The product has been used for purposes other than those intended for it, misused,
beaten, exposed to moisture, immersed in liquid or corrosive substances, as well as any
other fault attributable to the customer.
• The product has been disassembled, modified, or repaired by persons, not authorised by
• Make sure the robot is not in DND mode, it will not
resume cleaning under this mode. It won't resume
cleaning when it is placed manually on the charging
base.
• Make sure the robot is successfully connected to the
network and always in the range covered by the Wi-Fi
signal.
• Make sure the robot and the charging base are in an
area with good Wi-Fi signal, reset the router and try
connecting them again.
Frequency Bands: 2.412-2.472 GHz 5.150-5.250
5.250-5.350 GHz 5.470-5.725 GHz
Maximum Transmission Power: 16 dBm
ENGLISH
45