HoMedics AR-45 Manual De Instrucciones E Información De Garantía página 6

Replacing HEPA Filter
With regular cleaning the life of the HEPA filter is approximately 12-18
months under typical household usage and conditions. We recommend
replacing your filters every year. To purchase replacement HEPA filters,
model # AR-OTFL, go back to your retailer (where you purchased your air
cleaner), or visit www.homedics.com.
After cleaning or replacing the HEPA filters, be sure to reset the filter
indicator by pressing the CLEAN/RESET FILTER INDICATOR BUTTON for
several seconds until an audible chime sounds and the light turns off.
Replace UV-C Bulb Indicator
The UV-C Bulb is equipped with a REPLACE UV-C BULB indicator to let the user
know it is time to replace the bulb. When the bulb needs to be changed, the
REPLACE UV-C BULB indicator will light up on the control panel. Once the UV-C
bulb has been replaced, press and hold the REPLACE UV-C BULB button until it
beeps to reset the indicator. To purchase a replacement UV-C bulb,
model # PP-AROTUV, visit www.homedics.com.
Replacing the UV-C Bulb
1. Unplug unit and allow bulb to cool.
2. Open and remove the rear grill.
3. Remove the upper HEPA filter.
4. Use a screwdriver to remove two screws and detach the metal UV-C bulb cover.
5. Grasp the UV-C bulb firmly and pull it from the bulb socket.
6. Replace the new UV-C bulb and push it into the bulb socket.
7. Replace the metal UV-C bulb cover.
8. Replace the rear grill.
NOTE: UV-C bulb contains Mercury (Hg). Dispose of according to Local, State and
Federal Law / www.lamprecycle.org
1 0
Cleaning the HEPA Filters
Make sure that the air cleaner is turned OFF and unplugged from the outlet before
cleaning.
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
DO NOT USE WATER OR ANY HOUSEHOLD CLEANERS OR DETERGENTS
TO CLEAN THE HEPA FILTERS.
1. Open the rear grill by gently pushing
down on the tab on the top of the grill
plate. Fig. 5
2. Open the plate outward until the tabs at
the bottom of the grill plate easily slide
away from the unit. Fig. 6
3. Remove the HEPA filters from the main
unit. Fig. 7
Note: There are two HEPA filters in this
air cleaner.
4. Use the brush attachment with your
vacuum cleaner. Run the attachment
along both sides of the HEPA filters,
cleaning thoroughly between the
accordion folds of the filters. Fig. 8
5. Place the clean HEPA filters back in the
main unit, making sure they are firmly
seated inside the unit. Fig. 9
6. Place the tabs at the bottom of the grill
plate into the base of the unit. Gently
push the grill plate back into place until
you hear a click sound indicating that the
grill is firmly latched. Fig. 10
1 1