Danby DR200WGLP Guía De Utilización Y Cuidado Para El Propietario página 26

INSTALL THE ANTI-TIP BRACKET (cont`d)
STEP 2 SECURE THE BRACKET
The bracket must be screwed to either the FLOOR or the REAR
WALL.
FLOOR Installation
WOOD FLOOR: Use the screws provided to secure the bracket
using the pair of marked holes (Loc. A).
CONCRETE FLOOR: Using a concrete bit, drill a 5/32" pilot hole
2" deep into the concrete at the center of each of the marked holes
(Loc. A). Use the screws provided to secure the bracket into the
fl oor.
REAR WALL Installation
Use the 2 screws provided to secure the bracket using the pair of marked holes at Loc. B. The screws MUST enter into a
wood sill plate. If the wall contains any metal studs or similar materials, then the fl oor must be used.
STEP 3 CHECK THE BRACKET
After installing the bracket, slide the range into its fi nal location. To check if the bracket is installed and engaged properly,
look underneath the range to see that the anti-tip arm attached to side panel is engaged in the bracket. On some models,
the storage drawer or kick panel can be removed for easier inspection. If visual inspection is not possible, slide the range
forward, confi rm the anti-tip bracket is securely attached to the fl oor or wall, and slide the range back so the anti-tip arm
slides just under the anti-tip bracket. If the range is pulled from the wall for any reason, always repeat this procedure to
verify the range is properly secured by the anti-tip bracket.
The anti-tip bracket must be PROPERLY INSTALLED to prevent the range from tipping. NEVER remove the
leveling legs. This will prevent the range from being secured to the ANTI-TIP bracket properly.
All ranges can tip.
BURNS or other SERIOUS INJURIES can result.
INSTALL and CHECK the anti-tip bracket following the instructions supplied in this manual.
To reduce the risk of tipping the range, the range must be secured by a properly installed anti-tip bracket.
To check if the bracket is installed and engaged properly, look underneath the range to see that the anti-tip
arm attached to the side panel is engaged in the bracket. On some models, the storage drawer or kick
panel can be removed for easier inspection. If visual inspection is not possible, slide the range forward,
confi rm the anti-tip bracket is securely attached to the fl oor or wall, and slide the range back so the anti-tip
arm slides just under the anti-tip bracket. If the range is pulled from the wall for any reason, always repeat
this procedure to verify the range is properly secured by the anti-tip bracket.
If the range is pulled from the wall for any reason, always repeat this procedure to verify the range is prop-
erly secured by the anti-tip bracket.
INSTALLATION INSTRUCTIONS
IMPORTANT
WARNING
Attachment to Floor or Rear Wall
Attachment to Floor or Rear Wall
Anti-tip arm
Anti-tip
arm
25
Bracket
Wall sill plate
Screw must
Wall sill plate
Screw must
enter wood
enter wood
or concrete
or concrete
Screw must enter wood
Screw must enter wood