Assembling Your Yard Vacuum - MTD Yard-man 247.770380 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING - YOUR RESPONSIBILITY:
understand and follow the warnings and instructions in this manual and on the machine.
NOTE: Not all safety labels may apply to your Yard Vacuum.
SECTION 2: ASSEMBLING YOUR YARD VACUUM
This unit is shipped without gasoline or oil
IMPORTANT:
in the engine. Be certain to service engine with gasoline
and oil as instructed in the separate engine manual
before operating your machine.
NOTE: Reference to right or left hand side of the Yard
Vacuum is observed from the operating position.
Removing Unit From Carton
Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to open
carton.
Remove loose parts if included with unit (i.e.,
operator's manual, etc.)
Cut along corners, lay carton down flat, and remove
packing material.
Roll or slide unit out of carton and check carton
thoroughly for loose parts.
Loose Parts In Carton
Handle Assembly
Bag
Blower Chute
Hose Assembly
Disconnecting Spark Plug Wire
Before setting up your Yard Vacuum, disconnect the
spark plug wire from the spark plug and ground to a
stud on the engine.
(See Figure 1)
Restrict the use of this power machine to persons who read,
Blower Chute
Upper
Handle
Wing
Rope
Nuts
Guide
Lower
Handle
Hose
Assembly
5
Bag
Figure 1

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Yard-man 24a-060f402

Tabla de contenido