Makita EM2650UH Instrucciones De Manejo Originales página 18

At times, such as winter, when starting the engine
is difficult
Operate choke lever with the following procedure when starting engine.
● After implementing startup steps 1) to 3), set choke lever to the CLOSE
position.
● Implement startup step 4) and start engine.
● Once engine starts, set choke lever to the OPEN position.
● Implement startup step 5) and complete warm up.
CAUTION: If a bang (explosive sound) is heard and the engine stops, or the
just-started engine stalls before the choke lever is operated, return
the choke lever to the OPEN position, and pull the starter knob a
few times again to start the engine.
CAUTION: If the choke lever is left in the CLOSE position, and the starter knob
merely pulled repeatedly, to much fuel will be sucked in, and the
engine will become difficult to start.
STOPPING
1) Release the throttle lever (2) fully, and when the
engine rpm has lowered, set the I-O switch to
STOP the engine will now stop.
2) Be aware that the cutting head may not stop
immediately and allow it to slow down fully.
ADJUSTMENT OF LOW-SPEED ROTATION (IDLING)
When it is necessary to adjust the low-speed rotation (idling), perform it by the carburetor adjusting screw.
CHECKUP OF LOW-SPEED ROTATION
CAUTION:
The cutting attachment may be spinning during carburetor adjustments. Wear
your protective equipment and observe all safety instructions. Be sure the
cutting attachment stops turning when the engine idles.
CAUTION:
When the unit is turned off, make sure the cutting attachment has stopped
before the unit is set down.
– Set the low-speed rotation to 3,000 min
If it is necessary to change the rotation speed, regulate the adjusting screw
(illustrated on the right), with Phillips screwdriver.
– Turn the adjusting screw to the right, and the engine rotation will increase.
Turn the adjusting screw to the left, and the engine rotation will drop.
– The carburetor is generally adjusted before shipment. If it is necessary to
readjust it, please contact Authorized Service Agent.
.
-1
18
CLOSE
OPEN
STOP
(2)
EM2650LH
(1)
EM2650LHN
EM2651LH
Carburetor
Adjusting
screw
(1)
STOP
(2)
EM2650UH
EM2650UHN
EM2651UH