Quick Start - Refco REF-METER-OCTA 4679462 Manual De Instrucciones

English

Quick Start

To operate the REF-METER-OCTA as a basic weigh scale, perform the following steps:
Setup
1. Unpack the scale as described in the "Unpacking the REF-METER-OCTA" section
below.
2. Install the batteries into the control box as described in the "Battery Installation" section
below.
3. Place the Weighing Platform on a firm, level surface.
4. Turn the REF-METER-OCTA on by pressing
5. Select the proper measurement units by repeated pressing
follows:
kilograms
6. Select the desired display resolution by repeatedly pressing
RESOLUTION section.
Basic Weighing Operation
1. If using a container to hold the objects being measured, place it empty on the center of
the platform.
2. Press to "zero-out" the scale. The display will read zero.
3. Place the material to measure in the container or on the center of the platform.
4. Read the weight on the display.
5. A positive number indicates the applied weight is greater than the zero value. A
negative number indicates the applied weight is less than the zero value.
6. Turn the REF-METER-OCTA off by pressing
7. To conserve battery life, the REF-METER-OCTA will turn itself off after 30 minutes of
inactivity. The last state of the REF-METER-OCTA will be restored upon power-up.
pounds pounds and ounces
REF-METER-OCTA User's Guide
.
. The units will cycle as
ounces
as described in the
down.
5