Maintenance Wash; Cleaning The Detergent Dispenser; Cleaning The Drain Filter - Zanussi ZWT 71401 WA Manual De Instrucciones

Ocultar thumbs Ver también para ZWT 71401 WA:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CAUTION! Do not use alcohol,
solvents or chemical products.
DESCALING
If the water hardness in your area is high or
moderate, we recommend that you use a water
descaling product for washing machines.
Regularly examine the drum to prevent limescale
and rust particles.
To remove rust particles use only special products
for washing machines. Do this separately from the
laundry wash.
Always obey the instructions that you
find on the packaging of the product.

MAINTENANCE WASH

With the low temperature programmes it is possible
that some detergent stays in the drum. Perform a
maintenance wash regularly. To do this:
Remove all laundry from the drum.
Select the cotton programme with the highest
temperature with a small quantity of detergent.
DOOR SEAL

CLEANING THE DETERGENT DISPENSER

Clean regularly the washing powder and additive
dispenser drawer.
Regularly examine the
seal and remove all ob-
jects from the inner part.
Press the catch down-
wards and pull it out to
remove the drawer.
Flush it out under a
tap, to remove any
traces of accumulated
powder.
Replace the drawer and run the rinse
programme without any clothes in the drum.

CLEANING THE DRAIN FILTER

The pump should be inspected regularly and
particularly if:
the appliance does not empty and/or spin;
the appliance makes an unusual noise during
draining phase due to objects such as safety
pins, coins and so on blocking the pump;
a problem with water draining is detected (see
chapter 'Troubleshooting' for more details).
CAUTION! Switch the appliance off
and remove the mains plug from the
socket.
Proceed as follows:
Unplug the appliance.
If it is necessary, wait until the water has cooled
down.
A
B
Remove the top part of
the additive compart-
ment to aid cleaning.
Make sure that all
washing powder resi-
due is removed from
the upper and lower
part of the recess.
Use a small brush to
clean the recess.
Place a container
close to the pump (A)
to collect any spillage.
Pull out the emergen-
cy emptying hose (B),
place it in the contain-
er and remove its cap.
17

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido