Velleman CAMCOLD23 Manual Del Usuario página 10

Display: PRIVACY
OFF Privacy is switched off
ON Privacy function is active. Use the settings below.
 Select which of the 8 areas you want to define in AREA SEL
(1/8 ... 8/8).
Use the TOP, BOTTOM, LEFT, and RIGHT settings to
define the top, bottom, left, and right edge of the area.
 COLOR: sets the colour of the privacy area.
 TRANSP: sets the transparency for the privacy area.
 MOSAIC: creates a mosaic pattern in the privacy area. This
is useful if you want to make an area private, but still want
to use it for motion detection.
7.9 Day / night
The camera can switch automatically between colour images in day
conditions and black-and-white images in night conditions. Use this
function to control the day/night behaviour of the camera.
Note: black-and-white images are much clearer and contain less
noise at low light levels.
Display: DAY/NIGHT
COLOR The camera always makes colour images.
B/W The camera always makes black-and-white images.
 BURST: you can switch burst on or off to improve the
image quality. The burst function sends a colour signal to
the monitor in B/W mode. This may degrade the clarity
of the image.
AUTO The camera makes colour images during the day and black-
and-white images during the night. Use the settings below.
 BURST: you can switch burst on or off to improve the
image quality. The burst function sends a colour signal to
the monitor in B/W mode. This may degrade the clarity
of the image.
 DELAY CNT: delay counter. Defines the delay before the
camera switches from day to nigh mode or vice versa.
This prevents the camera from switching over too quickly
if the light conditions change only briefly.
 DAYNIGHT: sets the threshold for switching from day
to night mode. The lower the setting, the less light is
required to switch to night mode. Recommended settings
V. 02 – 30/05/2013
CAMCOLD23 - CAMCOLD23W
10 ©Velleman nv