Velleman CAMCOLD24 Manual Del Usuario página 5

2. Hold the mounting plate [1] and unscrew the fixation ring [2] by
turning it counter-clockwise. Note that the lens enclosure [5] and
positioning ring [3] are also released.
3. Use the mounting plate [1] to determine the position of the
mounting holes. Drill the holes.
4. Guide the power and video cable [11] through one of the cable
slots [10] and fix the mounting plate [1] on the ceiling or wall
with the four screws.
5. Position the positioning ring [3] over the lens enclosure [5] onto
the mounting plate [1] and then fix the ensemble by screwing
the fixation ring [2] onto the mounting plate [1]. Make sure the
fixation ring is not screwed too tight to leave the option open to
position the lens into the direction of the desired field of
operation.
6. Connect the video connector [A] to a monitor (not incl.) or a
sequential switcher/quad splitter (not incl.) in case of multiple
domes.
7. Connect the power connector [B] to a 12 VDC power supply (not
incl.).
8. Set up the desired field of observation by adjusting the position of
the lens enclosure [5] in the positioning ring [3].
9. Manually adjust the zoom [4] and focus [8] with their screws.
The location of the screws can be determined by looking at the
position of the light sensor [9].
10. Tighten the fixation ring [2] to secure the camera's position.
7. OSD Settings
There is a small joystick in the camera cable that allows you to
adjust the settings of the camera using an on-screen display (OSD).
In the OSD menu:
 NEXT/BACK: select this option and press the middle button to go
to the next/previous page of options in the menu.
V. 02 – 30/05/2013
CAMCOLD24 - CAMCOLD24W
 Press the middle button to access the menu, or
to select an option.
 Press the up and down buttons to move up and
down in the menu.
 Press the left and right buttons to modify the
menu parameters.
5 ©Velleman nv