How To Wire Your Ceiling Fan; Installing The Canopy Housing - Fanimation The Edgewood TF971 Serie Manual Del Propietário

If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a
licensed electrician.
▲WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
1. Connect the green grounding lead from the hanger
ball and the green grounding lead from the hanger
bracket to the supply grounding conductor (this may
be a bare wire or wire with gree colored insulation).
Securely connect wires with wire connectors supplied.
2. Securely connect the white fan motor wire the white
supply (neutral) wire using wire connector supplied.
Securely connect the black fan morot wire and blue
wire tho the black supply wire using wire connector
supplied (Figure 11). After connections have been
made, turn leads upward and carefully push leads into
the outlet box, withe the white and green leads on one
side of the outlet box ane the black and blue leads on
the other side ofh the outlet box.
3. Proceed to the next step of "Installing the
Canopy Housing".
NOTE: This step is applicable after the necessary wiring
is completed.
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 12a)
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figrue 12b)

How to Wire Your Ceiling Fan

Installing the Canopy Housing

Black
Fan Wire
Green Wire
(Ground)
Green Wire
(Ground) from
Hanger Bracket
Green Wire
(Ground) from
Hanger Bowl
HARDWARE USED:
WIRE
CONNECTORS
▲WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades are in place.
damage could result.
Figure 12a
8
Listed
Black
Outlet Box
Household
Supply
White
Blue
Figure 11
x 3
Noise and motor
Figure 12b