Lacava 4500G El Manual Del Propietario página 3

Installation Instructions/Instrucciones de Instalación
1. In order to provide proper support for wall-mounting a sink, it's usually necessary
to remove a small section of drywall so you can access the wall studs and attach
blocking between them.
2. Based on the sink's dimensions and mounting height (usually 30-33 inches above
floor), decide where support will be needed.
3. Remove the drywall in that area and install 2-by-6 or 2-by-8 blocking between
the wall studs. Then using 3 1/2" galvanized common nails, toenail the blocking
to the studs and repair the drywall.
4. If the studs cannot be used then ¾" plywood support behind the finished wall
can also provide the necessary support.
5. Place the sink onto the desired position on the wall and mark the wall through
the mounting holes on the sink. Then drill pilot holes for the mounting bolts, using
a masonry bit if the wall is tile.
6. Screw the wood threaded part of the mounting bolts into the pilot holes so that
the machine threaded portion is sticking out of the wall.
LACAVA LLC
7. Drain and trap assemblies will come
preinstalled by Lacava. Simply check
that the parts are still sealed and
positioned properly.
8. Place the protective strip along the bottom
of the glass, between the two mounting
holes towards the rear.
9. Slide the glass through its designated slot
on the ceramic base so that it sits all the
way back. Note: One person should hold
the glass in place, while a second installer
performs steps 10-12.
3