Tabla de contenido
Publicidad
LACAVA LLC
10. Install the glass mounting hardware in the order
shown in the diagram to the left.
From the bottom:
- metal washer,
- plastic washer,
- lower ceramic mounting hole,
- plastic washer with insert facing upwards
through glass,
- glass mounting hole,
- thick plastic washer,
- upper ceramic mounting hole,
- metal washer,
- then locking nut.
The mounting bolt should go through
both layers of porcelain and the glass
(three total mounting holes).
11. Tighten the locking nut so that the glass
is fully secure. Note: Do not over tighten,
as this may cause damage to the porcelain.
12. Repeat steps 10-11 for second mounting hole.
13. Install the faucet assembly onto the sink
and connect the supply lines to the water
supply.
14. Place the sink onto the mounting bolts,
making sure that the sink is positioned
properly and completely level.
15. Place the plastic sleeve onto the mounting
bolt first in order to protect the porcelain.
Then slide on the metal washer followed
by the locking nut. Tighten the nut so that
the sink is secure against the wall.
16. Again make sure that the sink is level
and then repeat step 14 for the second
mounting bolt.
4
Publicidad
Tabla de contenido
