Starting/Operation - Aqua Medic BLENNY Manual De Instrucciones

4.4. Set-up in a filter chamber
The Turboflotor Blue 500 has to be hung onto the separating pane of the filter chamber. The drain
gutter (5a) of the skimmer is extended downwards to guarantee a safe exit.

4.5. Starting/Operation

The system can be started when the Turboflotor is correctly installed. After switching on the pump,
air is automatically drawn into the skimmer. To minimize the noise level, connect the air inlet tube
with the blue connecting piece of the silencer supplied. Fix the silencer with the holding unit (15)
on the back of the filter separating wall. Please wipe the plate with a dry cloth, take off the foil of
the sticking side of the holding unit and press it firmly.
The mesh wheel breaks the air into small bubbles. This method eliminates the greater proportion of
noise. After the initial start, some hours may pass before the first foam is pushed into the
collection cup. This is due to a reaction between the surface of acrylic glass and aquarium water.
Equilibrium of electrical charges takes place. After a maximum of 24 hours, the foam should be
pushed evenly into the collection cup. The quantity of liquid and organic substances is dependent
on the pollution of the aquarium.
4.6. Problems
Adjustment
The skimmer is adjusted using the water level controller so that it works to its optimum. The water
level in the skimmer must be adapted to foam production. If the foam is too wet, the water level
controller (4) has to be further opened and thus the water level lowered. If the foam is too dry, the
process has to be done vice versa.
Air bubbles in the outflow
If the skimmer is added to an existing aquarium, there may be a high concentration of organic
substances already dissolved in the water. This results in very tiny bubbles in the skimmer. These
tiny bubbles remove the organic substances effectively, however, it may happen that some of
these bubbles are drawn back into the aquarium. After a few days, the concentration of organic
substances will have decreased to such low levels that this effect will have gone and the water flow
is free of air bubbles.
In new set-up aquaria, a reasonable adjustment is very rarely. The skimmer either „boils" or
„bubbles" without foaming power. This is normal and will be settled as soon as the basin is filled.
Some types of frozen food may have the same effects. It is best to thaw and wash the food prior to
feeding it to the fish. The air bubbles will stop after a short period by themselves.
If the air nozzle or air hose are blocked with salt or lime deposits, less air and more waters is
sucked in. In this case, clean both completely.
Wet foam
With freshly prepared sea water or after using water conditioners or at extremely high loading,
excessive wet foam may be produced. This wet foam is forced into the cup, requiring more
frequent emptying than normal. After approx. one day, the aquarium load should be normal and
the skimmer will produce correct foam. Lower the water level in the skimmer by turning the water
level controller (4). If necessary, clean the air injection nozzle, hose connection and hose of
deposits.
Dry foam / not enough bubbles
Not enough or too dry foam could be an indication that the mesh wheel or air injection nozzle are
dirty. A thorough cleaning is recommended. Remove the pressure nozzle from the pump. If it's not
a problem of cleaning, increase water level inside the skimmer by the water level controller (4).
17