Chapin 80088B Manual De Uso página 2

Auger is designed to work in forward motion. Excessive reverse motion could cause binding. If
resistance is felt while pulling spreader backwards, stop and clear salt from auger.
ASSEMBLY INSTRUCTIONS
Approximate assembly time is 5-10 minutes
Suggested Tools:
Wrench and/or Ratchet Set
• Remove bottom bolt from each side of
handle (below triangle shaped thumb screws)
• Loosen thumb screws and flip up handle
• Replace bolts below thumb screws and tighten down
• Tighten thumb screws completely
Bolts
Handle
* Note: If spring detaches from bail assembly,
simply re-attach (see Figure A).
CHAPIN INTERNATIONAL, INC. P.O. BOX 549 700 ELLICOTT ST. BATAVIA, NY 14021-0549 www.chapinmfg.com 800-950-4458
WARNING
Thumb
Screws
Figure A
Assembled