Usb Power Port; Work Light - Wagan Tech Power Dome LT Manual De Usuario

USB POWER PORT

1. Connect a user-supplied USB cable to the USB power port on the Power Dome.
2. Turn the Master Switch on.
3. Set the Inverter/USB Switch to "I" position. (You may also choose to operate the USB and AC
outputs at the same time by setting the switch to the "II" position.)
4. Operate your mobile device as usual.
5. After use, disconnect the USB cable and turn the Inverter/USB Switch off.
6. Recharge the Power Dome as soon as convenient.

WORK LIGHT

1. Turn on the Master.
2. Set the Light Switch to the "|" position.
3. The light will illuminate.
4. Turn off the light when it is not in use.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2020 Wagan Corporation. All Rights Reserved.
15