Hydraulic Connections - baltur RiNOx 35L Manual Del Usuario

HYDRAULIC CONNECTIONS

The pipes that connect the tank tothe burner should be in perfect tight condition; we recommend the use of copper or steel
pipes of an adeguate diameter.Fuel gate valves should be fitted at the end of the rigid pipelines.Fit the filter to the suction
pipeline after the gate valve. Connect the flexible fitting to this, which in turn should be connected to the suction of the burner
pump. Connect the flexible fitting to the return pipe after the gate valve, and then connect it ot the pump return. Filter, flexible
pipes and relative connecion nipples are standard burner accessories. The pump is provided with special connection points
for the insertion of control instruments (manometer and vacuumeter).To ensure reliable and silent operating conditions, the
vacuum in suction should not exceed 35 cm Hg equal to 0,46 bar.Maximun suction and return pressure 1,5 bar.
16
GRAVITY FEED FROM THE BOTTOM OF OIL TANK
GRAVITY FEED OVER THE TOP OF OIL TANK
SUCTION FEED
N.B. For any missing devices in the
pipping, conform to existing regulations.
H = Measurement between minimum oil level and pump axis
L = Max. legth of suction line, including vertical lifts. For each bend of valve deduct 0,25 m.
Ø i = Internal diameter of pipe
LIGHT OIL BURNER
1 Oil tank 6 Suction line
2 Feed line 7 Return line
3 Filter 8 Fire valve
4 Burner 9 Non return valve
5 Degasifier
H
meters
1
2
3
4
1 Oil tank 7
3 Filter 8
4 Burner 9
6 Suction line 10 Foot valve
H
meters
1
2
3
4
1 Oil tank 6
3 Filter 7
4 Burner 10 Foot valve
H
meters
0,5
1
1,5
2
2,5
3
3,5
N° 0002900860
Rev. 27/07/99
Total
meters
Ø i. 10mm
30
35
40
45
Return line
Fire valve
Non return valve
Total
meters
Ø i. 10mm
30
35
40
45
Quote P = 3,5 m (max)
Suction line
Return line
Total
meters
Øi. 10mm Øi. 12mm
26 54
24 47
18 38
14 30
10 23
6 15
- 7