Installing Flat Panel Screen To Wall Plate - PEERLESS SmartMount ST 640 Manual De Instalación Y Montaje

Mounting and Removing Flat Panel Screen
Hook tilt brackets (BB and CC) onto wall plate (AA).
3
Then slowly swing screen in as shown. Turn safety/
security screws, using phillips screw driver or security
allen wrench (FF), clockwise at least six times to
prevent screen from being removed as shown in detail 1.
of figure 3.1.
Screen can be adjusted horizontally if desired as
shown in figure 3.2.
Note: To lock the screen down, tighten screws to wall
plate using a phillips head screw driver or securty allen
wrench (FF) as shown in detail 1.
To remove screen from mount, loosen screws, swing
screen away from mount, and lift screen off of mount.
WARNING
• Always use an assistant or mechanical lifting equip-
ment to safely lift and position the plasma television.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
CAUTION
• Be careful not to pinch fingers when pushing screen
from the bottom.
Adjusting the Tilt Angle of the Flat Panel Screen
4 Unlock tilt position by loosening IncreLok™ tilt
locking screws on both tilt brackets. Adjust
tension knobs shown in detail 2 to desired
tension, balancing your screen size and weight.
Push or pull from top or bottom of screen to
adjust tilt as shown in figure 4.1. The tilt can be
adjusted to a maximum of 15° forward or 5°
backward.
Note: To lock the screen into the desired tilt
position, use locator hole to find tilt position.
Tighten IncreLok™ tilt locking screws on both
tilt brackets as shown in figure 4.1 and detail 2.
BB and CC
AA
SAFETY/
SECURITY
SCREW
DETAIL 1
TENSION
KNOB
LOCATOR
HOLE
IncreLok™ TILT
LOCKING
SCREW
DETAIL 2
8 of 24
All other brand and product names are trademarks or registered trademarks of their respective owners.
AA
ISSUED: 01-13-06 SHEET #: 202-9030-5 09-24-07
© 2007, Peerless Industries, Inc. All rights reserved.
fig 3.1
fig 3.2
fig 4.1