Futurelight LIS-69 Manual Del Usuario página 41

Rest
- Reset
With this function you can Reset the device via the Control Board.
• Select "REST" by pressing [UP] or [DN].
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Restore factory settings
With this function you can restore the factory settings of the device. All settings will be set back to the
default values (shaded). Any edited scenes will be lost.
• Select "LODA" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DN] to select "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
Ver
- Software version
With this function you can display the software version of the device.
• Select "VER" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "V-X.X", "X.X" stands for the version number, e.g. "V-1.0",
"V-2.6".
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Main menu 2
• Press [MODE/ENTER] to enter the main menu (display flashing).
• Press [UP] or [DN] to select "ADJU".
- Test function of each channel
With this function you can test each channel on its (correct) function.
• Select "TEST" by pressing [UP] ] or [DN].
• Press [MODE/ENTER], the display shows"T-XX", "X" stands for the channel number.
• The current channel will be tested.
• Select the desired channel by pressing [UP] or [DN].
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- PAN/TILT adjustment
With this function, you can calibrate and adjust PAN/TILT to their correct positions.
• Select "WHEL" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows"CODE".
• Press [MODE/ENTER], the display shows"CXXX".
• Enter the password "C050" by pressing [UP] or [DN].
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
• Press [MODE/ENTER], the display shows"CH-XX", "X" stands for the channel number.
• Select the desired channel by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows"XXXX", "X" stands for the calibration value.
• Adjust the desired calibration value between –128 and 127 by pressing [UP] or [DN].
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
41/87 00031008.DOC, Version 1.0