Basic Safety Rules - Tramontina TRF25 Manual De Uso

hammers
The shredding hammers have teeth on all 4 sides [Fig. 12, Pag. 12]. Change the usage position
whenever you detect wear and change the hammers whenever all four sides are worn out. To alter
the usage side remove the lock pins from the axis (1) and remove the released axis (2) through
the funnel for green products (Models TRF25, TRE25, TRE30, TR40 and TRE40) or through the lid
(Model TR50). Then change the operating face of the hammers [Fig. 13, Pag. 12].
!
Inspect the shredder before using and check whether there are tools or foreign objects
inside the grain or greens funnels.
• Never operate the machine while the lid is open.
• Do not use a damaged power cord, which can cause electric shocks.
• If the shredder fails to reach the required power, contact Tramontina Technical Support to check
the condition of your electrical power source to prevent burning the motor due to an overload.
• Check that the counter blade is properly adjusted and secured. After any heavy impact, always
tighten the shredder screws, especially the counter blade screws.
• Keep children and animals away from the shredder when it is being used.
• Do not allow inexperienced persons to operate the shredder unless they have read the
instruction manual first.
• Do not use the shredder during periods of likely power outages.
• Do not use the shredder for any purpose other than as specified in this manual.
• We recommend that only Tramontina parts made for the same model be used as replacement
parts.
• Never leave the shredder unsupervised while it is in operation.
• Always wear closed shoes and safety goggles while operating the shredder.
• The shredder should be installed on a clean, level floor that is free of oil, grease, debris,
buckling, inclines, etc. The area around the shredder should be unobstructed to allow operators
and materials to move around the area safely.
24

BASIC SAFETY RULES