Maintenance And Care; Troubleshooting - Schumacher Battery Extender BE01248 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

13. MAINTENANCE AND CARE

A minimal amount of care can keep your battery charger working properly for years.
• Clean the clamps each time you are finished charging. Wipe off any battery fluid
that may have come in contact with the clamps, to prevent corrosion.
• Occasionally cleaning the case of the charger with a soft cloth will keep the
finish shiny and help prevent corrosion.
• Coil the input and output cords neatly when storing the charger. This will help
prevent accidental damage to the cords and charger.
• Store the charger unplugged from the AC power outlet in an upright position.
• Store inside, in a cool, dry place. Do not store the clamps clipped together, on
or around metal, or clipped to the cables.

14. TROUBLESHOOTING

PROBLEM
Battery clamps do not
spark when touched
together.
All three LEDs come
on for 2 seconds, then
turn off.
The charger will not
turn on when properly
connected.
POSSIBLE CAUSE
The charger is equipped with
an auto-start feature. It will not
supply current to the battery
clamps until a battery is properly
connected. The clamps will not
spark if touched together.
The charger is plugged into
an AC outlet.
AC outlet is dead.
Poor electrical connection.
Connections are reversed.
Battery is defective.
• 12 •
SOLUTION
No problem; this is a normal
condition.
No problem; this is normal.
Check for open fuse or circuit
breaker supplying AC outlet.
Check power cord and
extension cord for loose
fitting plug.
Unplug the charger and
reverse the clamps. (The
charger will not detect reversed
connections when the battery
voltage is less than 2V.)
Have battery checked.

Publicidad

Tabla de contenido
loading

Tabla de contenido